Ask Experts Questions for FREE Help !
Ask
    pwmills's Avatar
    pwmills Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 19, 2013, 12:39 PM
    Bryant 350 mav ignition lockout
    My furnace is locked out because the igniter failed. I have replaced the igniter,do I have to wait 3 hours to reset.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Feb 19, 2013, 01:07 PM
    Try shutting the breaker for the heater off for a couple of minutes and then retry.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant 90 plus furnace 350 mav bu code 12 runs intermittenly [ 0 Answers ]

No problems other than motor continues to run then shut off and turns right back on what and how to fix please any help highly appreciatted

Bryant 350 mav furnace (propane) problems [ 0 Answers ]

"Woke up to cold house" blower was running but no heat. Checked unit and had a 13 code flash on LED. Made sure there were no obstructions in/out with airflow. Checked and cleaned flame sensor, replaced rollout switch (at advice of tech) and drained all of condensation at bottom of unit... If I...

Bryant Model 350 MAV condensing gas furnace? [ 2 Answers ]

I hear water flowing from the "pump" outside the furnace, that has a tubing connected to a train tube by the sink nearby. I looked inside the bos ("pump"), there is some solution (like antifreezer) inside, but vary shallow. What should I do to silent this pump, or to fix this problem?

Bryant 355MAV error 34 & 14 Ignition Lockout [ 13 Answers ]

Hi everyone, I own a Bryant 355MAV furnace which has been installed since Autumn 2001 and run without trouble since then (except a minor airflow issue last winter which was helpfully solved here in this forum). I've been running the heater for most mornings since early October without issue....

View more questions Search