Ask Experts Questions for FREE Help !
Ask
    Coby14's Avatar
    Coby14 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 25, 2013, 10:19 AM
    T and p valve
    Can you install a long shank t and p valve on a water heater that has a short shank one in it

Check out some similar questions!

Hot water problem - faulty check valve or mixing valve? [ 8 Answers ]

Hi, We have a weird problem with hot water running cold in our apartment. At all of the faucets and taps we only get hot water for a minute or two and have to turn off the faucet/tap for 30 seconds and back on again to get hot water. Then the same thing happens again. To get continuous hot...

I have a early 90's Kohler shower valve and rounded out the cold stem valve seat. [ 2 Answers ]

Should I drill then retap the threads? Thanks!

I'd like to install a ball valve on main water line will a "Viperlok" valve work? [ 1 Answers ]

I know sweat soldering a ball valve is best, but will a "push-ft" compression "Viperlok" brand ball valve work?---My pipes are old copper, and have a few minor scratches and pits---I also noticed a seam running down one side of pipe. This water line runs out into garden, but valve is in the house....

Cold water pressure relief valve leaking, not the TRP valve [ 5 Answers ]

Hello. Cold water pressure relief valve start to drip water through the drain pipe. I replaced it with a new one but it is also dripping water. I have reduced water pressure in the house to the minimum by turning main water supply valve but it still leaking. Thanks for your help.

Can I solder outlet side of a ball valve if the valve is closed and under pressure? [ 0 Answers ]

Can I solder outlet side of a ball valve if the valve is closed and under pressure?

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.