Ask Experts Questions for FREE Help !
Ask
    rainstorm26's Avatar
    rainstorm26 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 24, 2013, 04:05 AM
    High efficiency furnace water in induction motor
    I have had water collecting in my induction blower motor of my 10 yr old high efficiency furnace for the last 6 days. I was emptying it periodically and it will run okay for a while and then do the same. It would run for about 8 hrs then trip out after draining. I cleaned a lot of gunk out of the hoses/drain lines and such. Then it ran well for several days. However again this morning it happened again. There was one section of pipe I was not sure that was clear, that I was able to push some water through this morning. If this does not fix the problem, any other suggestions? Thanks

Check out some similar questions!

Water in furnace induction motor [ 13 Answers ]

Hello I have a new Goodman 90% efficiency furnace. The induction motor keeps getting water in it and then the pressure switch trips. The drain is not plugged and is flowing good. Any help would be appreciated. Thanks Dan

Goodman GKS9 Furnace Induction motor issue? [ 3 Answers ]

Goodman GKS9 furnace is giving issues. The LED flashes 3 times which the manual says is caused by blocked flue, blocked air inlet, pressure switch hose, or bad pressure switch. Induction motor works fine. I snaked both outside air lines, blew out the pressure switch hose, and finally replaced the...

Concord 90 plus high efficiency furnace? [ 0 Answers ]

Our heater broke and I was wondering where can I get the Honeywell gas valve VR8205S2346 or is there another model that would fit for our heater?

Single-phase induction motor versus 3Phase-induction motor [ 1 Answers ]

I know the advantages of 3phase induction motor (IM) when compared with a single-phase IM one. However I need to justify using a single-phase IM (main and auxiliary windings) with a 3 legs inverter instead a 3phase IM with also a 3 legs inverter. Are the single-phase IM cheaper the 3phase one...

Goodman furnace induction motor [ 2 Answers ]

My 1 year old furnace (mid-efficiecy Goodman) has an induction motor which will kick in and allow the burners to start. The burners will flash on and then shut down quickly. Induction motor will kick on again and then the burners. It might shut off again but then the blower starts and the...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.