Ask Experts Questions for FREE Help !
Ask
    ggray's Avatar
    ggray Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 17, 2008, 12:11 PM
    Goodman furnace induction motor
    My 1 year old furnace (mid-efficiecy Goodman) has an induction motor which will kick in and allow the burners to start. The burners will flash on and then shut down quickly. Induction motor will kick on again and then the burners. It might shut off again but then the blower starts and the burners will stay on. Heat will eventually be brought up to and held at the temp requested. Also, the induction motor is very loud with it starts up.
    acetc's Avatar
    acetc Posts: 1,004, Reputation: 79
    Ultra Member
    		  
    #2

    Mar 17, 2008, 05:57 PM
    I would say you need a new motor, good luck, Mike
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #3

    Mar 17, 2008, 06:25 PM
    If your unit has a flame sensor I would try to clean it or just replace it. Your induction motor is probably under warranty since Goodman has a 5 year warranty on parts.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Water in furnace induction motor [ 13 Answers ]

Hello I have a new Goodman 90% efficiency furnace. The induction motor keeps getting water in it and then the pressure switch trips. The drain is not plugged and is flowing good. Any help would be appreciated. Thanks Dan

Goodman furnace ECM motor blowing too much air? [ 5 Answers ]

I installed a Goodman GMV95 two speed gas furnace with ECM fan motor last fall. It functioned perfectly last winter, cutting my natural gas bill almost in half. When I installed the unit, I set it for 720 cfm (my ductwork is a little small for 95% efficient equipment) and verified the airflow by...

Goodman furnace induced draft motor [ 3 Answers ]

On a call for heat the draft motor starts but the air proving switch does not close. I replaced it with the same result. Everything works normally if I close the switch manually with my own air pressure. Someone told me that somethimes the motor, due to age (this one is 13 years) will not spin fast...

Goodman furnace fires up, but no blow.(new motor) [ 1 Answers ]

The furnace fires up for a few minutes but the blower motor doesn't engage. Then the safety switch kicks in and turns the flames off. You can hear the click of the relay and the low moan of the motor trying to go. Sometimes it'll click on.. you hear the motor strain... then click off, then click...

Goodman AC/Furnace: condenser not coming on after installation of new blower motor [ 6 Answers ]

Have and outside Goodman AC unit and Goodman furnace (inside duh!). Anyhoo, after installing new blower motor the AC unit will not kick on. Have reset outside breaker, and double checking wiring on controller board on furnace, noticed one blue wire was disconnected, reconnected that and still not...

View more questions Search