Coleman evcon furnace problems

vlhamby Posts: 1, Reputation: 1

New Member

Jan 15, 2013, 05:01 PM

Coleman evcon furnace problems

When switch comes out of set position, the pilot light goes out.

Grady White Posts: 1,417, Reputation: 59

Ultra Member

Jan 16, 2013, 08:32 PM

Most likely the thermocouple needs to be replaced.

Add your answer here.

Check out some similar questions!

Coleman furnace heat setting for coleman evcon furnaca modeld g a 207 5800 [ 0 Answers ]

Where is the heat anticipator setting for a coleman evcon furnace model dga2075800

Coleman evcon furnace problems? [ 1 Answers ]

Coleman Evcon Furnace DGAT090BDD Furnace kicks on blower stays on when you check there is no heat coming through the vents. Look at the furnace and the green indicator light is blinking 4 times. Have woke up every day this week with the tempature in my house 58 degrees. What is wrong??

Coleman evcon furnace problems [ 1 Answers ]

The diagnostic light blinks twice on Coleman Evcon #DGAHO56BBSA 5600BTU natural gas forced air out bottom Mobile home heater. 2 blinks is supposed to be "combustion air switch stuck closed" which is called a pressure switch in the part manual. When I restart the furnace cylce and place suction on...

Coleman Evcon Furnace [ 1 Answers ]

We have a Coleman Evcon DLAS075BDD furnace which keeps displaying error codes: 1-Ignition Failure and 4-Limit cycling. We have replaced the circuit board. Inspected the ignitor and the flame sensor and both appear good. Also have taken the exhaust vent/hood off and vaccuumed out any rust to...

Coleman Evcon fan problems [ 1 Answers ]

The fan on my Coleman Evcon furnace, installed in 2003, does not work properly on automatic. It will shut off and not kick back on. I have to let the everything cool down for a while before the furnace with start working again. If I run the fan on "On" the furnace works but you can hear the fan...