Ask Experts Questions for FREE Help !
Ask
    heliflyer09's Avatar
    heliflyer09 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 24, 2012, 02:04 PM
    Blower motor on constant, board replaced, all sw's closed
    We had a power outage, and, after power was restored, my blower motor was running constantly. I replaced the controller board, still same. I checked all limit switches I could find, and all were closed, opening did nothing to keep the blower from running. I checked the safety fusible link, from the hot box sensor, which was closed, and the FL is good. The electronic ignitor is not coming on. The thermostat was bypassed and same action. At a loss for what else could be bad...
    Still a bad board, after replacing?
    heliflyer09's Avatar
    heliflyer09 Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Dec 24, 2012, 02:07 PM
    I have a Payne/Carrier HH84AA011 furnace... sorry didn't mention before. Little hard to diagnose without that!
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #3

    Dec 24, 2012, 04:48 PM
    What is the LED light flashing on the control board? Is this an upflow or downflow furnace? If this is a downflow furnace (main blower assembly located on top side of furnace) Im betting you missed a reset-able aux limit. Many time very hard to see, let alone get to to reset. Let me know and I will try my best to help out.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace gmpn080-4 no power to blower motor replaced motor [ 1 Answers ]

Getting 110v to the transformer and purge motor but 0 volts to the blower motor from the circuit board

Have a blower motor that still will not come on even after replaced with a new board. [ 0 Answers ]

Have an electric furnace; have replaced new control board and fan for blower will not come on when set in auto or on position. Have the blower motor straight wired now and blower works perfect; blowing good heat; any ideas?

Replaced blower motor [ 1 Answers ]

I have replaced new blower motor and capacitor but the blower still not running

Recently replaced furnace control board, now blower will not come on with AC. [ 3 Answers ]

I recently replaced a 50A50-110 control board (Comfortmaker) with a White-Rodgers universal 50M56U-843 control board and the furnace worked fine throughout the winter. However, I just tried the AC for the first time this season and the blower will not come on with the AC. The compressor and outside...

I have a bryant 397h furnace and the blower will not shut off.replaced circuit board [ 2 Answers ]

I have a bryant 397h furnace and the blower will not turn off.I replaced the control center circuit board and still runs. Any suggestions?

View more questions Search