Rudd flame clicking on and off very quickly

scipiopj Posts: 2, Reputation: 1

New Member

Dec 20, 2012, 06:07 PM

Rudd flame clicking on and off very quickly

The fire does not go out completely. It goes on and off very quickly. I cannot find a flame sensor. It has a eletronic ignitor.

Check out some similar questions!

Trane XE 80, flame "pulsing" and clicking. [ 0 Answers ]

I have a trane xe 80. When I start it, it ignites fine, but after about 2-3 minutes, it starts clicking and the flames 'pulse', as if the there is a motor that is feeding gas not running properly. Any advice?

Beckett burner starts has flame for about 15 seconds off for 12 then flame on & runs [ 7 Answers ]

I have replaced the following with the problem still happening: replaced the primary control(R8184G 4009), cad cell--the oil unit was service at the beginning of the heating season. Ran like a champ. Now for the past two weeks with new parts the problem is: Oil burner starts with a flame for...

Rudd heater runs the flame will not stay on to heat [ 1 Answers ]

I Have a Rudd Heater it has a electronic ignighter it comes on lights the flame, but the flame will not stay on, the heater runs but the flame comes and goes, it will not stay on and heat the house

John Deere L110 Clicking sound on start - new solenoid, still clicking! [ 1 Answers ]

Hi all, I cut my lawn, engine was running for about 2 hours. Stopped at neighbors house, cold beer, go to restart, just a clicking sound. Thought battery was dead, did a quick check, good voltage, hooked it up to a charger, good amps. Still clicking. I figure it's the solenoid, picked one up...

View more questions Search

Check out some similar questions!

Add your answer here.