Ask Experts Questions for FREE Help !
Ask
    masterofone's Avatar
    masterofone Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 6, 2012, 11:55 AM
    FAILURE GMP075-3 Control Board
    I activated the thermostat, draft fan came on briefly, ran for maybe two full seconds and stopped. I re-set thermostat and again draft fan came on but this time even shorter than the first. Third attempt did nothing, no draft fan. Control board is hot, LED not blinking but steady. I metered draft fan 110vac contacts, no voltage. I disconnected draft fan 110vac to board and ran the fan with a jumper so its not the fan. My guess is the board mounted power relay but there are two, I don't know which to replace. I have a junk board to get a relay but I don't want to waste my time. Any one know which is which ? Any suggestions ? Thanks

Check out some similar questions!

Control board for goodman gmp075-3 furnace serial number0005601329 [ 0 Answers ]

I have a goodman gmp075-3 furnace serial number 0005601329 that will not start up. I have done some troubleshooting as outlined below: 1) turn thermostat up and exhaust motor comes on. Igniter does not glow and furnace light on board flashes 5 times. 2) Checked and am not getting 24V to gas...

Trane xe80 control board failure replacement [ 0 Answers ]

I have just replaced my TRANE XE 80 control board and the fan comes on immediately and the LED blinks 5 times. I have checked all the rollout sensors and the fan and blower sensors and they are good. I have jumped all the sensors out at the control board and still get the same result. I have...

Trane xe80 internal control board failure, red light on steady [ 1 Answers ]

Trane xe80 internal control board failure, red light on steady

Trane xe80 internal control board failure, red light on steady [ 0 Answers ]

My furnace runs for a while then the flame goes out but the blower keeps running. Control board has solid red light that means internal control board failure (replace)I turn off the power to the unit and then turn back on, it runs for a while then repeats. Seems to get worse the colder it is outside

Lennox control circuit board failure? [ 0 Answers ]

I have a Lennox G40UH system that is not engaging the inducer motor. I swapped out the inducer and the pressure switch from the downstairs unit and I'm still not getting any power to the inducer. Is there another way to verify if the ignition control circuit board is faulty?


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.