Ask Experts Questions for FREE Help !
Ask
    nick___'s Avatar
    nick___ Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Mar 4, 2011, 08:22 AM
    Trane xe80 internal control board failure, red light on steady
    Trane xe80 internal control board failure, red light on steady
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Mar 4, 2011, 09:32 PM
    Nick, In the previous post you said you can not locate the control board?? Its good to see you found it. Diagnostic light of control board failure is control board failure. The board will need to be located and replaced.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trane xe80 internal control board failure, red light on steady [ 0 Answers ]

My furnace runs for a while then the flame goes out but the blower keeps running. Control board has solid red light that means internal control board failure (replace)I turn off the power to the unit and then turn back on, it runs for a while then repeats. Seems to get worse the colder it is outside

The red light has a steady blink no hesitation [ 0 Answers ]

This is freongas again, I just wanted to say that the red light in the unit blinks the same no indication of a code. This is for the carrier 58gs100-2 that pilot lights but no fire and on blower is it the PC board?? Heeeeeeelp!!

Goodman furnace won't ignite, burning steady is the little red light. [ 4 Answers ]

Hi, I have a Goodman GMT gas furnace. It is only 4 years old. Two days ago it stopped working. When I checked it out, it seems that the furnace is getting the signal from the thermostat fine, however, the power venter fires up and then right after the gas valve opens, there's a click (which I am...

Trane XE80 Control Board / Booster Fan Questions [ 4 Answers ]

The blower on my parents Trane XE80 gas furnace stopped working this weekend and a local HVAC company diagnosed the problem as a bad control board. The technician didn't have a board on his truck so he temporarily bypassed the control board and wired the fan to stay on 100% of the time until he...

View more questions Search