 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Trane xe78 thermal protection device open?
I jumped the two wire on the limit switch and the burners still did not fire up. The fans just start blowing cold air. The diagnostic panel flashes a light 4 times. I took out the limit switch and put a lighter under the thermal sensor and I can hear it click. And as it cools it clicks again. I ordered another. Waiting on that now
|
||||
Check out some similar questions!
I have a XB-90 furnace that indicates the Thermal Protection Device is on. The blower motor runs, but burners do not kick on. I have looked for reset switches to no avail. Help.
My furnace is a Trane with a White-Rodgers 50A55-480 control module. I have been tinkering with it for over 6 months now. I have replaced the ignitor unit and also steelwooled the other unit on the other side. I used to be able to move all the wiring left and this would allow the furnace to...
Getting 4 blinking lights. Furnace lights kicks on and works for like 5 minutes then shuts off but the fan keeps blowing then it repeats over and over again.
I have an American Standard Freedom 80. The blower turns on when heat is called for but as the glow plug is not "lit", no gas comes through and there is no ignition = NO HEAT. I am very ignorant to the workings of furnaces and need some advice. Do I simply try to replace the glow plug? How can...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
