Ask Experts Questions for FREE Help !
Ask
    hammer57's Avatar
    hammer57 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 17, 2012, 04:52 PM
    2000 windstar motor turns over but will not start
    2000 windstar won't start -- replaced coli pack, cam & crank sensor. What else could it be?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Nov 17, 2012, 05:45 PM
    . Check all under hood and under dash fuses with a test light or multimeter. This may lead you to a bad ignition switch.

    . Check for codes.

    . Ensure the CEL comes on and then goes out, when the ignition switch is turned to ON. If not, there may be an issue with the PCM.

    . Clean the main PCM ground.

    . Ensure the fuel pump runs, when the ignition switch is turned to ON.

    . Ensure there is more than a token amount of fuel in the gas tank and that the fuel rail is fully pressurized.

    . Check shift interlock solenoid, if the problem persists.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

'97 toyota tercel won't start it turns the motor over but doesn't want to start? [ 3 Answers ]

I have checked fuel pump and changed spark plugs. I have know idea why it won't start or is hard to get started. When it does finally start it runs great so I think that would rule out the timing belt. If you have any suggestions I would appreciate it.

Motor turns over, won't start. [ 1 Answers ]

I'm working on my mother in law's 96 dodge ram. I had to replace the motor in it for it. I dropped it in, hooked everything back up. Unfortunately, the motor won't start. It turns over though. There is no spark in the coil. Any help?

Kohler motor turns over but will not start. [ 1 Answers ]

I found a used Toro Riding lawn mower with a 20 hp kohler motor. The mower has not been run in about a year. Prior to not using the mower it was operational and had been tuned up at a local shop. Now it will not start. Motor turns over but will not start. I changed the gas, cleaned the fuel...

View more questions Search