Ask Experts Questions for FREE Help !
Ask
    SMMS60's Avatar
    SMMS60 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 14, 2012, 08:01 AM
    Does the Tyco 1116377-2 NM splice need to be enclosed in an electrical box?
    Can these Tyco NM splices be buried in the wall?
    hfcarson's Avatar
    hfcarson Posts: 1,003, Reputation: 49
    Ultra Member
    		  
    #2

    Nov 14, 2012, 08:26 AM
    Do the installation instructions of this splice kit specifically allow this? If not, then you cannot bury a splice in a wall in accordance with the electrical code...
    This is not a good practice to begin with as most of us have searched for a splice that has gone bad only to find that is was buried in a wall somewhere.
    What would you need to do to splice this in box?
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #3

    Nov 14, 2012, 09:06 AM
    The Code, Section 334.40(B), that allows these devices to be used for exposed, or fished in existing buildings, is clear about no boxes would be needed, but not clear if this connection requires access.

    I would not use these when the connection would be buried in a wall.
    hfcarson's Avatar
    hfcarson Posts: 1,003, Reputation: 49
    Ultra Member
    		  
    #4

    Nov 14, 2012, 10:02 AM
    Reading up on the Technical specs for this connector on the TYCO website,
    Yes, it is listed for and allowed to be concealed by the electrical code.
    But again, I agree with TK, try to avoid burying this in a wall...
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wanted! Tyco's My puppy loves me! [ 0 Answers ]

I need help, for christmas I only want one thing, to reclaim this lost childhood toy. I found a name now. It's from 1992. It was called Tyco's My puppy loves me! They had a few different styles available, but the one I'm looking for is located here:...

Is an enclosed LB OK [ 1 Answers ]

Does it pass code to have an LB in a wall cavity say between a meter base and a main service panel thus eliminating the need to see it mounted on the exterior of the building?

Tyco infloor heat cables [ 2 Answers ]

I have a tyco infloor heat cable that failed last spring. We heard a clicking sound from the circuit breaker panel and started to smell smoke from an area on the floor. We shut down the one zone and found the smell coming from an area by a wall. I still have 2 zones left and it looks like the...

Electrical Splice [ 2 Answers ]

What is the best technique to use when splicing romex wire that will wind up in a conduit?

Using Tyco Splicing Device [ 5 Answers ]

I need to re-route some romex 12 gauge wire in my basement ceiling. I've got a Tyco Cable Splicing Device. In the instructions, it does not show the individual wires as being stripped, but they don't fit very well if they are not stripped and I'm not sure if they would make a good contact if they...

View more questions Search