Ask Experts Questions for FREE Help !
Ask
    svpauhana's Avatar
    svpauhana Posts: 5, Reputation: 1
    New Member
    		  
    #1

    Nov 10, 2012, 01:36 PM
    Pressure washer bogs down
    Craftsman gas pressure washer bogs down when spray wand trigger is released. If trigger is held open it works fine & engine runs at all speeds. Unloader needs to be adjusted but don't know how to do it. Unloader has large spring surrounding slotted stem adjustment screw.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Nov 15, 2012, 05:24 PM
    Hi,
    You are correct that the unloader is not working, but without a model number it is not possible to know who made it for Sears. You can go to the Sears parts site with that number at:
    http://www.searspartsdirect.com/part...t/index.action
    Peace,
    Clarke
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #3

    Nov 15, 2012, 07:34 PM
    Many times it just takes a good cleaning and a lub with lithium. How to Fix a Pressure Washer (Part 1 of 2) - YouTube
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Pressure washer [ 5 Answers ]

Does anybody know how to adjust the pressure regulator oin 2600psi troy bilt?

Cannot get air out of pressure washer pump [ 4 Answers ]

Cannot get pressure washer to give a stedy flow of water

Briggs and stratton engine bogs under pressure [ 1 Answers ]

I re built the b&s engine on my craftsman pressure washer the motor starts right up and runns fine until I pull the triger then it bogs really bad but stays runningany sudjestions on what the cause might be would be much appreicated.

Gasoline pressure washer pressure locked [ 2 Answers ]

When I release the spray trigger on my Sears Gasoline Pressure Washer to change positions it will not start spraying again. Is this "pressure Lock"? How do I correct it so it will spray again? The motor continues to run. This morning it worked fine. I changed nothing, but this afternoon it...

What should water pressure be for washer? [ 3 Answers ]

Hi, my washer started "leaking". The repair guy said was from too low water pressure or flow into that "cup" in the washer the water "jets" into (that "cup" is required by law for some reason). Anyway, I'm on a well. I have a water pressure of about 29 to 32 psi (it was higher I think... I'm going...

View more questions Search