 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Heil main burner will not light
Heil Ultimate III
When heat is needed, circulation fan starts for a bit, then pilot ignition lights for about 10 seconds. Since the main burners do not start the pilot shuts off. The circulation fan still runs. Error code is 6 flashed then 2 (6+2). Decal on furnace says this means: retry dealt-third failure to light on same call for heat -new trial for ignition after 5 minute delay. Tried resetting power but same thing happens every time. |
||||
Check out some similar questions!
My main burner will not light. After the hot water heater power cycles three times, the hot water heater shuts down and the following error code is displayed: 100110 which the owner's manual says is System Lockout Things I have tried: Repositioned the igniter assembly several times...
The main burner of my Magic Chef Ultra II furnace will not light normally. The furnace has an electronic ignition. Its blower, electronic igniter and pilot burner seem to be functioning normally, but the main burner won't fire up unless I blow on the pilot flame several times. When I do blow on the...
I have a Bryant Plus 90 furnace, model 398AAW036080D , series G. The draft inducer and pilot light go on, but the main burner doesn't light. While tapping on pressure switch with a screwdriver handle the main burner ignited. The switch is attached to a rubber diaphram. It has a yellow, orange,...
Hi all. I've got my pilot to light no problem. Then I turn gas knob to "on" as per instructions. I "adjust" switch on thermostat on wall only to hear clicking noise coming from inside panel of fireplace but the main burner doesn't light (like it used to last winter). I believe it's the main...
Hello, I have a Rheem forced air furnace, gas, (mod# RDG-10EQGR) and main burner won’t light The prepurge vent motor starts and after 34seconds the hot surface ignitor glows red, 34 seconds later I hear the relay click in the ignition module for the burner valve, but valve doesn’t open and no...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
