Ask Experts Questions for FREE Help !
Ask
    rogie66's Avatar
    rogie66 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 11, 2012, 12:41 AM
    Goodman gmpn060-3 status led on
    My furnace does not kick in. A.C. Works so I know its not fan. The red led is constantly on. I just hear a slight humming sound. No water in the small rubber hose. Thermostat turned up high... could it be heat sensor?
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Oct 11, 2012, 05:26 AM
    The humming you hear,, does the draft inducer motor come on?
    That is the 1st step,first thing you should hear after turning up the tstat,, if motor is bad and its not running it should feel very warm to the touch
    rogie66's Avatar
    rogie66 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Oct 11, 2012, 03:01 PM
    Quote Originally Posted by wmproop View Post
    the humming you hear,,,,,does the draft inducer motor come on?
    that is the 1st step,first thing you should hear after turning up the tstat,,,if motor is bad and its not running it should feel very warm to the touch
    The humming is a slight electrical type humming. My A.C. works normally... blower fan comes on and blows cold air. When I switch to heat... nothing at all. My red LED is constantly on... which is a good thing I think... What else can I do before I make the call?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman GMPN060-3 (5 Blink Diagnostic Code) [ 4 Answers ]

Hi, I have a Goodman GMPN060-3 gas furnace. I get a 5 blink diag code, the indoor blower comes on. It worked OK for 3 hours this morning, I had to have the board replaced back Nov 04, I am wondering if it is going bad again, I am on disablity with limited income, any help will be gratefully...

Goodman Furnace Model GMPN060-3 Three Blinks Diagnostics. [ 7 Answers ]

I have a Goodman Furnace Model GMPN060-3. I get three blinks biagnostic code. I changed venter (motor assembly) and pressure switch. Still the same three blinks. Moisture drain path is clean and free of debries. After the new parts, furnace started once, but would not start again -- same three...

Goodman furnace gmpn060 flashing codes [ 0 Answers ]

Inducer motor runs, flame lights for a few seconds, goes off. Tries 3 times then turns off. Signals with 1 blink. So far, flame sensor has been cleaned, safety switches tested, Inducer motor safety switch has been jumpered out. Nothing changes.

Goodman GMPN060-3 Blower Cycles [ 2 Answers ]

I have been in my house for 5 years when the thermostat calls for heat, the inducer blower comes on and almost immediately I hear the pressure switch click and then the relay on the main board clicks and the inducer blower goes off. This happens over and over for a couple of minutes and finally...

View more questions Search