 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Trouble shooting trane xe furnace
I have a Trane XE 80 gas furnace and a Trane air conditioner. I cannot get either one to come on when I call for the heat or cool. Blower will not respond either. I can get furnace to fire if the manually do it at the furnace, but it cuts out after about 30 seconds. What could be the problem
|
||||
Check out some similar questions!
My clare furnace will not come on. When I turn the furnace on noting happens. But if I turn the main fan switch on it comes on. But when I turn the thermostat up the small fan doesn't come on which in turn will not let the furnace work
My furnace is blinking 3 times and won't turn on. I have a Trane XR80 and no manual or trouble shooting codes. Could somebody please tell me what it means when it blinks red 3 times and won't turn on? Thanks... very cold:confused:!!
How much dose the cercuit board cost?
Hello I have a Altra 90 SX Armstrong furnace that has a cycle problem. The model # is a GUK75D103A with a Heatcraft control board 404030001 Cat. # 70K98 The problem that I'm actually having is that it is going through its cycles OK, except the induced fan keeps running and won't shut off. ...
I have an Coleman Evcon Furnace. Model #15020A the problem is I replaced the Inducer motor, and The furnace starts like normal but then the flames goes out after about a minute or two. The LED light says the Pressure switch is stuck open but it seems fine. I tried to replace the PC board but can't...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
