Trane xe 80 furnes trouble shooting

Gordon9948v Posts: 1, Reputation: 1

New Member

Dec 13, 2009, 05:36 PM

Trane xe 80 furnes trouble shooting

How much dose the cercuit board cost?

twinkiedooter Posts: 12,172, Reputation: 1054

Uber Member

Dec 13, 2009, 05:47 PM

Should be less than $200 for the part.

Add your answer here.

Check out some similar questions!

Trouble shooting a Trane xr80 Furnace [ 13 Answers ]

My furnace is blinking 3 times and won't turn on. I have a Trane XR80 and no manual or trouble shooting codes. Could somebody please tell me what it means when it blinks red 3 times and won't turn on? Thanks... very cold:confused:!!

Trouble shooting my T.V. [ 1 Answers ]

I have an older model rear projection television, the video and sound both went out at the same time, anyone have an idea on what I need to change out

Trouble shooting [ 1 Answers ]

hi I have 1997 dodge ram 1500 4x4 my tail light went out and then the single light would . Cheeked out both. Bulbs on the right side, know the kicker is the hazzards work, the turnsignal works, if I step on the break.pleas help. Note I have replaced the turnsignal switch. still no luck.

Furnace Trouble shooting [ 1 Answers ]

I have an Coleman Evcon Furnace. Model #15020A the problem is I replaced the Inducer motor, and The furnace starts like normal but then the flames goes out after about a minute or two. The LED light says the Pressure switch is stuck open but it seems fine. I tried to replace the PC board but can't...

Trouble shooting GMP Furnace [ 1 Answers ]

I have a gmp075-4 gas fired furnace, I just replaced the gas valve and the thing starts up fine but when the burner fires and the hot bar goes out the burner goes out any ideas? Limit switch maybe ?