Ask Experts Questions for FREE Help !
Ask
    cubcadetcowboy's Avatar
    cubcadetcowboy Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 17, 2012, 04:21 PM
    Craftsman weed eater won't stay running unless you keep mashing the bubble
    If I keep pressing the bubble lightly it will stay running
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Aug 25, 2012, 10:41 AM
    Hi,
    Clooged inlet screen, fuel filter or bad diaphragms, I believe in that order.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Weed Eater Lawnmower won't stay running [ 5 Answers ]

I have a Weed Eater Briggs and Staton 300 push mower. I've changed the spark plug and cleaned the Air Filter. Lawn mower will start but immediately shuts off. Any advice?

Poulan Weed eater won't stay running [ 2 Answers ]

I have a Poulan Weedeater Featherlite Plus that will not continue to run. It seems as though the tank gets pressurized and when I open the gas cap there is a surge of air into the tank. I don't know if this is supposed to happen or not. There are 2 tubes into the gas tank from the carburetor. One...

Craftsman weed eater won't stay running [ 2 Answers ]

I have a 2 yr old 25cc Craftsman POS weed eater. It starts on one pull and runs perfect for about 3 minutes, then boggs out. I have replaced fuel lines and filters, replaced the gas with a perfect mix, cleaned air filter, and stripped down and cleaned the carb fully. I am real close dumping it...

Weed Eater will not stay running [ 1 Answers ]

I have a Weed Eater model GTI 19T that will not run longer than a few seconds. Any suggetions?

View more questions Search