Ask Experts Questions for FREE Help !
Ask
    steve birdwell's Avatar
    steve birdwell Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 24, 2012, 05:30 PM
    Disassemble electric clutch on ez4824 husqvarna zero turn mower
    Remove electric clutch on my ez4824 husqvarna zero turn mower. When engaging blades it blows 7.5 fuse.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Aug 2, 2012, 03:18 PM
    Hi,
    Sounds as if you have too much air gap causing too much current draw. Try adjusting the air gap to 0.010 - 0.012"
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can an electric clutch on a yth2148 Husqvarna lock up in the engaged position [ 1 Answers ]

When trying to start the mower the blades are trying to turn but the starter is not strong enough. When I took the primary deck belt off engine started fine. So the clutch is stuck in the engaged position even with the pto switch off. How can I unstick it or what should I try.

Toro zero turn electric clutch clicks won't start [ 1 Answers ]

All safety switchs working I saw aspark come from the clutch so I shut it off would not start so checked around and found a blown fuse replaced it now all it does is click at the electric clutch please help

Husqvarna will not turn over but runs with a jump [ 6 Answers ]

Howdy, I have a Husqvarna cz3815 zero-turn mower with a 15 hp ohv briggs & stratton engine. While cutting the lawn, it stalled, then after a few minutes, it started again. This happened a few more times, now it will not even turn over or even click. I have checked the starter and ignition...

Craftsman 20.0 electric start 42 inch automatic lawn tractor mower clutch [ 2 Answers ]

We have a Craftsman 20.0 hp electric start 42" mower automatic lawn tractor Model 917.270940 and it appears the cable that allows you to engage the blades has broken. How do you either fix this problem or do we need to purchase a new cable. If we need a new cable how is it installed... I need...

Troy-bilt mower and electric PTO clutch [ 1 Answers ]

I am replacing the lower drive belt on my 23hp Troy-bilt pedal drive garden tractor. The last step in removing the belt is to remove the hex bolt from the center of the electric PTO clutch. When I try to loosen the hex bolt part of the electric clutch and the engine pulley turns at the same time....

View more questions Search