Check out some similar questions!

Poppao · Jul 18, 2012, 06:55 AM

The HEATED DRY light stays on. It looks like 1/2 bright

rcaldwell · Jul 18, 2012, 09:28 PM

If the "heated dry" light is stuck on and it is half bright it sounds like you have a bad control panel. It's an expensive fix but if you do it yourself it's not so bad. Before you replace control panel however, I would open the door and put your hand by the heater and check for heat. Don't touch the heater, you're just feeling for heat. If it's stuck on then your control board is bad - stuck relay. Hope this helps,

Rich
Western Appliance Repair Boise 208-863-3702

Poppao · Aug 27, 2012, 08:56 AM

Thanks for the reply. The heating element is cold to touch. Any suggestions?
Where is the control panel located?

Originally Posted by rcaldwell

If the "heated dry" light is stuck on and it is half bright it sounds like you have a bad control panel. It's an expensive fix but if you do it yourself it's not so bad. Before you replace control panel however, I would open the door and put your hand by the heater and check for heat. Don't touch the heater, you're just feeling for heat. If it's stuck on then your control board is bad - stuck relay. Hope this helps,

Rich
Western Appliance Repair Boise 208-863-3702

Poppao · Aug 27, 2012, 09:12 AM

[he heating element is cold. Any additional siggestions?

Thank you for your reply
Poppao