 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
John deere 727A Mower Deck won't engage
Hello,
I was mowing a pasture with a JD 727A lawn mower. I took a turn and the mower turned off. I turned off the knob and tried to restart it, but it didn't work. I tried this a couple times. Most of the times the belts twisted slightly, like it was gearing up to go, but then just stopped. The belts only moved about a half inch. I checked the deck and cleared if of all the debris and checked to make sure the belt worked. The actual engine will push the lawn mower, but the blades won't spin. THere's a lot of leaves near the wires and fuses but I'm not sure if that's were the problem is. Any suggestions? Will |
||||
Check out some similar questions!
I have a John Deere L130 lawn tractor and when I pull the PTO switch to engage the deck the mower tries to die and won't engage the deck. Could it be that the PTO switch is faulty and needs to be replaced or is it something else that's wrong ?
I have a John Deere riding mower 100 series model #gx155ca026001. The blades will not engage when I pull the knob next to steering wheel. I checked belt and nothing is jammed. I was mowing some thick, tall grass prior to this. I took belt pulley covers off and there was a lot of grass jammed in...
I have a John Deere L120 mower. The mower deck will not engage but the switch seems good. No power appears to be at the clutch on the mower deck.
My mower will start and run perfectly but will not engage in forward or reverse. There feels like there is hydraulic pressure when pushing the petals, but no going anywhere. I have removed the blade deck and the belts underneath are in good order and are tight.
Hi - I am looking for help on the routing for deck belt for John Deere 420 with 50 inch deck. Any help would be appreciated. [email protected] Thank you ! Steve
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
