 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Baxi barmuda GF back boiler
I have just replaced hot water cylinder in the attic, connected all pipework including flow and return to baxi barmuda GF back boiler, filled cylinder up header tank full hot water taps are running fine, however the back boiler has an air block as I changed all valves on the radiators and before I fit radiators back I was going to flush out the pipework so water is nice and clean, however there is no flow now to raidiator pipes and I am sure the back boiler has an air blockage, how can I get this blockage free so water will run through pipework to rads, is there a valve to let air out on the baxi barmuda GF back boiler, HELP.
|
||||
Check out some similar questions!
I have a tbar shower and it has just started when I turn it on its hot then after 2-3mins it goes cold so I run the hot tap in the sink when its hot turn it off then the shower goes hot
I have a baxi 30rs boiler. Over 10 year old. Still fires up OK, but after about 50mins the boiler shuts off and pilot light also goes out. Gas engineer looked and said the thermostats were working OK, but he thought the reason was because the boiler might be scaled up causeing it to overheat and...
I have a Baxi Luna Boiler that is aprox 3-4 years old. It heats my floor and my tap water. It gives me a Faulty Pump-Low Pressure Alarm. I pulled the inlet screen... the pump is running... but still no hot water. On the right hand side of the pump there is a yellow valve, I opened it hoping to...
I have a Baxi 105he boiler installed in 2005.In the last month I noticed that I have to pressurise the boiler because it reads zero. When the heating is running the pressure builds up to 3bars. Can anyoe shed some light as to what might be happening? Many thanks
The flow of hot water has reduced and the water is very hot the cold water flow has not been affected what could the problem be
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
