Ask Experts Questions for FREE Help !
Ask
    flmskr1's Avatar
    flmskr1 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 6, 2012, 06:01 PM
    Maytag LDG7304aae dryer heating problems
    I have been having problems with the dryer heating up. I have already replaced the high temp sensor, cleaned out all the tubes of lint. Now the flame comes on for about 30 seconds then goes out and does not come back on. Any other suggestions?
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    Jul 7, 2012, 12:07 PM
    Did you clean the flame rod and clean out all air passages? Just miss one air passage and it will not work.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

No Heat from Maytag Dryer LDG7304AAE [ 12 Answers ]

We've had this Maytag LDG7304AAE with us for over 10 years working without any issues but just this week, the dryer stopped working. We are able to start it, set the timer, etc. and it rotates as usual but there is no heat. We've not touch the thing since it was installed, any ideas as to what is...

Maytag model LDG7304AAE gas dryer does not heat enough [ 1 Answers ]

The flame ignites and stays lit but it does not seem to put out enough heat. It takes 2 to 3 times longer to dry clothes than it use to. Air flow is good,I cleaned all the ducts. I have by passed the High Limit Thermostat to make sure it is not kicking out but do not know where to go next.

Maytag ldg7304aae dryer making noise when starting [ 0 Answers ]

Maytag dryer #ldg7304aae? [ 2 Answers ]

Dryer heats up but drum doesn't turn

Maytag LDG7304AAE Dryer Intermintent heat [ 1 Answers ]

I have a Maytag dryer LDG7304AAE model, approx 15 yrs old. I have replaced the ignitor, Hi-temp switch, and coil, in 2006. Everything seemed to work fine, however for the past several months the heat was intermintent. I replaced the timer and the coils in Dec 2008. Seemed to work fine, but again,...

View more questions Search