Check out some similar questions!
3/4" or 1" emt
[ 2 Answers ]
My ongoing project; Small subpanel in attached garage- feeders will be #6 THHN copper and eqpt. Gnd. #10 THHN copper. Per Table C.1, 3/4" EMT will take four #6 THHN. The run will have two 90 degree bends and a total length of approximatley 23 ft. From and "ease of pull" standpoint will I...
Minimum distance between emt conduit for data and emt conduit for power
[ 1 Answers ]
Minimum distance between emt conduit for data and emt conduit for power?
EMT conduit
[ 7 Answers ]
Hi again guys! I'm running about 8 feet of metal EMT conduit from a baseboard heater, into a junction box in the joist cavities of my basement (ceiling, or first floor joist cavity). The baseboard is 2000 watt, 240 volt, and my code here stipulates that 14/2 will suffice with 15 amp breaker. I'm...
Wires in emt
[ 2 Answers ]
How many #12 wires in 1/2and3/4 metal tubing emt.allowed.
Rigid or EMT
[ 2 Answers ]
Planning some remodeling. Main breaker panel, currently within five feet of the meter, may be moved approximately 12 feet due to the size of the panel and framing considerations. A listed service disconnect will be placed at the old panel location, and rigid used from meter to disconnect. ... View more questions Search
Add your answer here.
|