 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Huskee riding mower won't turn over initially, but will after sitting
We purchasede a used Huskee Hydrostatic (one of the 690 models) riding mower a month ago. When we looked at it initially it started right up - and did so the next two times we used it. Since then, when you turn the key it sounds like it wants to start, but the part under the hood you can see that the rotating screen won't turn - almost like it is locked up. Then, if you let it sit a while and try it again, it starts. Very frustrating. Battery is new and charged, seems to have fuel in the line/filter. Once the machine has been used and is warm, it will start right away. Any ideas, before I pull my hair out??
|
||||
Check out some similar questions!
I have a huskee riding mower and we just replaced the drive belts. They are too tight so the clutch will not engage fully until it had run for quite a while. After it warms the belt enough, it will engage better. It still does not engage to its full potential, however. Is there a way to just adjust...
My huskee riding mower 17.5 hp briggs ! Starts missing running bad when I engage the mower deck
Replaced battery with new one, within several starts the new battery was drained. Mower will start by jumping but only runs a few minutes then dies, also the PTO will not engage at all (replaced PTO switch and still won't engage) does not even attempt to engage, as if there is no power to the...
I need a diagram of this specific deck so that I can place the spring correctly. I already have a diagram for the placement of the belt but when the old belt broke it knocked the spring loose and I do not remember where it goes. Thank you. It's a 50" Huskee Lawn tractor, 2004, 25 hp
I'm looking for some parts for a Huskee riding mower, I have a model number but, I do not have a book. Anyone know of a good resource? Thanks!
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
