Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Hydronic heating pipe size
[ 4 Answers ]
I wish to install a hydronic kick plate heater but it only has 1/2" inlet & outlets the zone has 3/4"pipe should I put in a bypass around the heater to keep the flow the same?
Max pipe size in load bearing walls
[ 2 Answers ]
I have a 2" line stubbed for a drain in an area of a 15' basement that will be framed 8' high with the rest used for storage above. Are these walls now considered load bearing? What's the maximum size pipe I can run through a load bearing 2x4 wall assuming I'm using a protective plate.
Soil Stack Vent Pipe/Stench Pipe ( Smelly Drains )
[ 3 Answers ]
I have a downstairs toilet and upstairs toilet ,one above the other.. The soil/stench pipe connects upwards to above the Roof heaves and downward into the sewer... Coupled into the sewer also is a Gully trap drain to take sink and bath / shower wastes and from time to time , from that drain gully...
Pvc pipe size per code
[ 1 Answers ]
I have a 1982 double wide cavco that sits above ground. I had a slow drainage problem in the tub and shower. I called the plumber out, actually three of them worked on the issue, and was not resolved. The supervisor explained that after trying for four hours, they were going to call it quits. He...
Question about pipe size
[ 1 Answers ]
Hi,everyone, I am confused about the pipe size for a urinal. The specification for one brand flushometer says that: 1" IPS angle stop and 1 1/4" top spud I don't know where the top spud is. If my water supply line pipe size is 1 1/4" IPS, should i find a flushometer with 1 1/4" angle stop or 1... View more questions Search
|