 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Replace heat pump thermostat
I am trying to replace a Bryant 34427dp120 thermostat with an Edge Pro 33cs thermostat. The Bryant thermostat has wires labeled - going clockwise at top - G, Y, W1, E, W2, F, O, R, T. The Edge Pro has Rc, Rh, W/W1, G, Y/Y2, C, O/W2/B, Y1.
I can correspond Y, W1, O, R but am at a loss how to connect E, F, W2 (separate from O), and T. T might be the same as C. |
||||
Check out some similar questions!
Trying to replace a Bryant heat pump thermostat with 8 wires connected with a Honeywell RTH3100C. Instruction guide says if W1, W2, and Y were connected, contact a HVAC tech. Honeywell customer service was no help. Any ideas?
I have a new house with heat pump. Although the thermostat senses the outdoor temperature and will auto select cool or heat, it will not that the next important step to auto select emergency heat when outdoor temperature is below set point. What should the emergency heat set point be? Is a heat...
I have a Carrier Series 50QT Electric heat pump that still uses the original non programmable thermostat. I am trying to replace it with Honeywell TH6000 series programmable thermostat. The wiring on the existing Thermostat as follows: O - White, I am thinking this is the Reversing Valve? Y...
I need to replace a Honeywell T841A1001 thermostat on a heat pump, and of course they do not make this one anymore. The old thermostat wiring was as follows" R = Red O = Orange G = Green Y = Yellow W2 = White with Jumper to X
I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
