Ask Experts Questions for FREE Help !
Ask
    Caterer.'s Avatar
    Caterer. Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 22, 2012, 01:45 AM
    7.3 dropped valve ?
    I have a 93 7.3 1 ton idi the truck was driving great then started making a loud chattering noise and losing power I pulled over to check it out and it wouldn't crank back up you can turn it almost a full rotation with a breaker bar on the crank but then it just hits a hard spot I pulled the valve covers but all springs were still in there place what's going on here? Thanks for any help.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    May 22, 2012, 09:45 PM
    Sure you didn't throw a rod? The valve springs could stay in place with a dropped valve since the rocker arm and valve keepers are still in place. P
    .
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

B&S 14HP OHV intake valve/ worn cam lobe or tappet valve? [ 16 Answers ]

Hi, I've scoured the postings and found many people with similar problems but only 1 or 2 with identical problems to mine. I have a Toro Timecutter 14-38Z (model 74301 serial 230004085) zero turn mower with a Briggs %26 Stratton 14HP OHV engine (model 280H07-0166-E1) and it only has about 120 hours...

Hot water problem - faulty check valve or mixing valve? [ 8 Answers ]

Hi, We have a weird problem with hot water running cold in our apartment. At all of the faucets and taps we only get hot water for a minute or two and have to turn off the faucet/tap for 30 seconds and back on again to get hot water. Then the same thing happens again. To get continuous hot...

I'd like to install a ball valve on main water line will a "Viperlok" valve work? [ 1 Answers ]

I know sweat soldering a ball valve is best, but will a "push-ft" compression "Viperlok" brand ball valve work?---My pipes are old copper, and have a few minor scratches and pits---I also noticed a seam running down one side of pipe. This water line runs out into garden, but valve is in the house....

Cold water pressure relief valve leaking, not the TRP valve [ 5 Answers ]

Hello. Cold water pressure relief valve start to drip water through the drain pipe. I replaced it with a new one but it is also dripping water. I have reduced water pressure in the house to the minimum by turning main water supply valve but it still leaking. Thanks for your help.

Can I solder outlet side of a ball valve if the valve is closed and under pressure? [ 0 Answers ]

Can I solder outlet side of a ball valve if the valve is closed and under pressure?

View more questions Search