Ask Experts Questions for FREE Help !
Ask
    Charkencorp's Avatar
    Charkencorp Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 12, 2012, 07:22 PM
    How to repair my kenworth elite dishwasher
    I have a kenmore elite dishwasher 665.13793k600. It would not turn on. I ran the series of normal wash heated wash 3 times and all lights turned on When I close door or try cancel it will not start or run cycle. Any suggestions?
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    May 13, 2012, 06:07 AM
    1. Press and hold "Heated Dry" for 4 seconds to unlock control panel.
    2. Press these buttons in quick succession: "Heated Dry," "Normal Wash," Heated Dry," "Normal Wash" to instruct it to run diagnostic test.
    3. Wait 2 minutes.
    4. When test is completed press "Cancel/Drain."
    If there is any standing water in dishwasher you will have to press "Cancel/Drain" before starting this. Make sure the float is not stuck in up position on bottom of tub.
    mjacoway's Avatar
    mjacoway Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Nov 3, 2013, 08:00 AM
    Dishwasher has standing water so draining problem how do I fix
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #4

    Nov 3, 2013, 09:17 PM
    You need to find out why it is not draining. Either it is stopped up or the pump does not run. It has to be one or the other. Once you find out you then move on to what to do about it. It should not be too hard to figure out.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore elite dryer repair [ 1 Answers ]

My dryer is dead when hit the button it will not come on in the past when it has done that I would just unplung for a few minutes then it would start now it will not do anything I brought n 2006 brandnew what can I do to get it working again

Kenmore Elite Dishwasher [ 0 Answers ]

The washer runs through the cycles, goes to drain and when finished draining stops and the clean light blinks 8 times pauses blinks once and then repeats until the door is open and restarted.

Kenmore Elite Dishwasher repair [ 1 Answers ]

I have a Kenmore Elite Dishwasher. The cycle buttons are not working. Any way to fix this without repairman?

Kenmore Elite Dishwasher [ 1 Answers ]

I have a Kenmore elite Dishwasher, How do I reset the control panel? I hit the start button and I get a 9 second countdown in the display timer then the dishwasher turns off.

View more questions Search