Ask Experts Questions for FREE Help !
Ask
    rnipp's Avatar
    rnipp Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 11, 2012, 07:04 AM
    Honda riding mower 3013, warning buzzer does not turn off
    Honda 3013 ring mower. The brake warning buzzer comes on in forward and reverse, so it will stall the engine in seconds. The brake is not engaged.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    May 11, 2012, 08:30 AM
    The brake set pull has a small switch that closes when the brake is set. Apparently that switch is shorted out or out of adjustment and senses the handle has been pulled. Do you have a manual? http://powerequipment.honda.com/pdf/...s/31763800.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

3013 honda mower [ 2 Answers ]

I just put in a new starter and battery. It will start quickly and run for about 1.5 minutes very smooth. Then it will back fire a couple times and shut off. When I looked into the motor the starter was smoking hot. Any ideas what would cause this? After it cools down it starts right back up...

Riding mower won't turn [ 1 Answers ]

I had a craftsman riding mower gave to me I have had one before and this one will not turn its like turning a truck with now power stearing is there a belt or something that I need to replace??

Riding mower won't turn over/start [ 1 Answers ]

I have a Snapper riding mower. Whenever I try to start it with the key, I hear a clicking sound coming from what I think is a relay between the battery, ignition switch and the starter. I've replaced the battery with a new, fully charged one. I've also gone through and cleaned all of the...

Honda Riding Mower #3013 won't start [ 1 Answers ]

My Honda 3013 rider has been a great machine for 12 years. While mowing it died just like you shut the switch off. My buddy trouble shot all the safety switches and found them fine. He said it was either the ignition switch or the module (epoxy sealed) behind the battery. I located these parts on...

View more questions Search