 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
There is a diagram right inside the cover.
Line goes to the two outside screws (1 & 3) The motor load goes to the two inside screws (2 & 4) Here is the instructions wiring diagram: http://static.schneider-electric.us/...013-005-39.pdf |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I had a 2 hour power outage over night and this a.m. The water pressure is very weak when flushing a toilet and running a tap at the same time or running a tap for a long period. The square d pressure switch does not have a reset lever on it and I used an emery board to clean the contacts in the...
Went to check my sister in laws water pressure as they had none. I found that the breaker was tripped at the water pump site and there was on 15# of pressure on the gauge. Reset the breaker and the pressure built up to about 60psi then settled down again to 40. It is a square D 30-50 pressure...
The electrical line from my water well pump control box to the well was cut and we lost all water pressure, repaired line and I still have no water is there a reset on the square d pressure switch. I have power 240 coming out of the control box but not to the well no other cuts in line.
I recently purchased a house that is serviced by a well. The pressure tank is located outside next to the house in a small shed. The previous owner wired a receptacle into the square-D pressure switch to allow them to power a light bulb to keep the pipes from freezing. The circuit is protected...
My well pump does not shut off after building up pressure 20-25lbs of pressure what is wrong thanks fsherman
View more questions Search
|
