Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
1993 camry 4cyl auto No compression
[ 0 Answers ]
I have just had the head machined, new gasket and bolts. Drove it just fine for a day then went to start it and it turns over but won't start. Have been told its either timing belt( but that was checked when doing the head) no compression. What has caused this and how can I fix it?
Find the EGR VSV on my 97 4cyl Camry
[ 2 Answers ]
I feel a little dumb, but I can not find the EGR VSV on my 97 4cyl Camry. I find, it seems, two VSV units - but neither seem to be EGR VSV. As I stand leaning over drivers side fender looking in to engine compartment - I quickly see and identify two similar units. Not the one in the image of...
1996 camry LE 4dr sedan 4cyl cranks but won't start?
[ 3 Answers ]
Yesterday my camry was running fine. After the engine was off for about 4 hours, I tried to start it and nothing happened -- no cranking, no clicking noise, no bells, no dash lights. I jumped the battery (battery's about 2 years old) and still no cranking. I looked at the fuse blocks near the...
97 Toyota Camry 4cyl. While driving it Died!
[ 7 Answers ]
97 Toyota Camry 4cyl. While driving it Died! While driving it stalled and came to a stop. It was spurting like it was going to run out of gas (before it died) but the tank is 3/4 full. While trying to start it up again it sounds like the starter is just spinning. All the Belts turn while trying...
My 1990 toyota camry (manual trans) dies while I am driving it.
[ 2 Answers ]
I replaced the wires, distributor cap, and rotor. Also put in a used distributor. Just stranded me again. What now? View more questions Search
|