Ask Experts Questions for FREE Help !
Ask
    bluescheese's Avatar
    bluescheese Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Mar 17, 2012, 04:28 PM
    95 honda won't fire,starter works
    I got 4.75 volts result from the K-test.Have installed a new fuel pump that operates when I jump 1-7 on relay conn.The relay is new.Relay conn. Shows activation by ignition switch and I was able to get car to run by shooting starter fluid in manifold.The pump and fuel injectors don't activate with the key.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Mar 17, 2012, 05:32 PM
    . Check all under hood and under dash fuses with a test light or multimeter. Especially test the ACG (ALT) (S) fuse in the under dash fuse box. It's likely in the upper right-hand portion of the fuse box. If it's missing, replace it.

    . Clean the main ECM ground, located on the thermostat housing. It likely has 3 wires going to a brass connector.

    . Check the ignition switch for wear, pitting, or melting.

    . If the Check Engine Light consistently comes on for 2 seconds and then goes out, when the ignition switch is turned to ON (Position II), then the problem is likely with the distributor. Usually, replacing the Ignition Control Module (ICM) and coil solves the problem. Be sure to apply silicone heat transfer grease to the back of the new ICM.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I want to know how do a DC motor starter works [ 1 Answers ]

I want to know how do a DC starter motor works,the equation involved and the diagrams involved.

Noma snowblower 8hp electric starter works but will not turn the flywheel [ 5 Answers ]

I have a noma 8hp snowblower... I replaced the starter today because I thought the old one didn't work anymore. I put the new one in and it did the same thing as the old one. I plug it in and press the button and the starter turns but it sounds like its grinding... there's only one place the...

Circulator pump works but oil burner does not fire [ 6 Answers ]

Hello, I have a 2 zone heating system, forced hot water with oil burner/boiler. Also heats domestic hot water tank/coil. Everything works fine EXCEPT zone 2, which is only the living room. When the thermostat is turned up, the circulator pump goes on but the oil burner will not. The...

Is the starter on honda harmony1011 + ground or - ground, my starter only works + gro [ 0 Answers ]

Honda harmony 1011 +ground or - ground,my starter only works on + ground.

2001 Honda Civic - Starter - Can you show me the location of the starter? [ 3 Answers ]

I'm having starting problems with my 2001 Honda Civic EX 4DR. This is the first problem with the car and I can't find the starter. Can you help?

View more questions Search