Replaced ignition lock but car cranks but will not start

Check out some similar questions!

I replaced my ignition lock (cylinder keys) [ 0 Answers ]

I put a new one but can't get the keys out of there... Help please

93 honda accord; put key in ignition car goes dead. Shift lock works radomly. [ 1 Answers ]

Daughter's new 93 honda accord. Put key in ignition and car goes dead; lights out. Fixed it once by using shift lock and moving shifter. Car booted up and cranked normally. Didn't work next time. Problem is random.

I changed my key lock cylinder out, now the car cranks but won't start.what did I do [ 1 Answers ]

I have a 95 honda civic. I changed the key lock cylinder and now my car only cranks and won't start, is there something I could have done wrong that would cause this? I only disconnected 3 pieces off the assembly to remove it... one wire clipped in the other 2 were connected to plastic pieces...

Car cranks but will not start [ 13 Answers ]

My nissan sentra will crank over and tries to start but will not start.Just last week it started to chug a little after turning the key and then ran fine,now it will not start at all.

Car Cranks, Won't Start, Tried Everything, desperate! [ 6 Answers ]

Ok, I recently did a motor swap in my daily driver, because the motor finally went out on my 1988 Honda Civic DX. The motor that I put into my car is, a DOHC ZC 1991 engine. I used a PM6 ecu, and changed my wiring from DPFI to MPFI. The ZC has not started for several months, and it has been very...

View more questions Search

Check out some similar questions!

Add your answer here.