Ask Experts Questions for FREE Help !
Ask
    spluvs2install's Avatar
    spluvs2install Posts: 16, Reputation: 1
    New Member
    		  
    #1

    Feb 18, 2007, 09:13 PM
    91 crx codes
    Ok, I went and did some snooping around today at my vehicle and the codes I got from the ECU are as follows.

    3- MAP sensor

    6- coolant temp sensor

    10- TA sensor

    13 PA sensor

    20- electrical load detector

    As far as MAP is concerned, I believe I have a bad ground there. The vehicle ran find yesterday and the cooling fan kicked on and never overheated, but then today the car didn't start, just cranked over, so it could be possible that somehow the damn coolant sensor went bad, somehow,. yeaaa, so anyway, has anyone had these problems with their vehicle or do you think I need to replace the ECU? I can do the field tests on each particular device if I need to, but chances are, they might lead me to a new ECU, oh man, I'm fustrated. OK, maybe someone will have a clear mind. What would your next move be?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Feb 18, 2007, 09:35 PM
    Perform the K-Test. This is a show stopper if it fails. Turn ignition ON and test for 5 volts between the MAP Sensor connector reference wire (+) and ground. If it fails, replace your ECM. I don't believe it's realistic to have that many different codes being thrown, unless the ECM is bad.
    spluvs2install's Avatar
    spluvs2install Posts: 16, Reputation: 1
    New Member
    		  
    #3

    Feb 18, 2007, 10:21 PM
    Can you tell me which wire would be the reference wire you can tell so this way I have 2 sets of eyes instead of just mine. Thanks!
    spluvs2install's Avatar
    spluvs2install Posts: 16, Reputation: 1
    New Member
    		  
    #4

    Feb 18, 2007, 10:26 PM
    From what I see on my diagram I have

    White wire on an end
    Green/white wire in the middle and it has a (-) next to it
    Yellow/red wire on the other end and it has a (+) next to it
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

89 CRX problems [ 9 Answers ]

Hello, new to this site, and thanks in advance. Great site. Well here goes. My car wouldn't start, no spark, so I took off distributor cap and saw that there piece (rod?) that goes into the coil was fried. I replace the cap with a new one, still didn't fire up. I then replace the ICM, it...

1991 CRX won't start [ 3 Answers ]

Own a 1991 CRX DX w/ 1.5 dual point fuel injection. Went to start car last week, stumbled on the first crank and nothing after that. Engine cranks but no spark. Having replaced dist w/ a junkyard unit 13 months ago, I suspected this one also failed. Replaced w/ reman unit from your favorite parts...

1988 Honda crx [ 1 Answers ]

This car has been setting for two years, won't start. We're going to try the fuel pump first. Is the fuel pump located under the back seat-driver's side?

1996 CRX won't start-please help! [ 3 Answers ]

Hi there! I bought a 96 CRX 1.6Esi four days ago, went to start it today and nothing happened! It just made some clicking noises! I had a look at some of the questions people have asked in the past and I think it sounds quite similar! I did the three questions and the CEL light comes on and goes...

91 Honda CRX Ignition [ 2 Answers ]

The key was getting stuck in the ignition so we replaced the key cylinder. It did not help. We have noticed this only happens in the morning when it is cold outside. What could we do to prevent this?

View more questions Search