 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
What is the cost to convert crossover plumbing to y?
How do you determine if your plumbing is a crossover rather than a Y? The plumbing in our two bathrooms, built circa 1963, is back to back. If it is a crossover, what is the average cost to convert from crossover to Y? I want to purchase two flush assisted toilets like the Toto Carlyle II and understand you can't install them if there is crossover plumbing.
|
||||
|
||||
|
Hi Nwoods...
If built in the 60s then most likely you have a cross tee fitting installed... ;) To guess at the cost would be irresponsible really as each town/state charges so differently it would be no different than throwing a dart at a dart board! Call some local plumbers for free estimates. I am sure there are plenty of companies glad to work with you on this. Good luck! Mark |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I had a Bosch Aqua star GWH 2400es-ng tankless water heater installed last May 2010 by an general contractor. I have already noticed a few issues. First off while in the shower the water will cycle between hot and cold, even when no other water source is used. It irritates me to have to fine tune...
How much would it cost to convert a 3 story home from gas heat to electric heat
We had a single sink vanity in place. Now we're remodeling and will be getting a 60" double sink vanity. Unfortunately I cannot use the stubs/drain that are existing, because the vanity has cabinet/drawer vertical supports that are right where the current supplies stub out. Can someone tell me...
Hello I am removing a tub and replacing it with a prefab shower base and need some drain and waste help. I have good access underneath. Existing is a 3" copper waste pipe and I was thinking that I could cut a small section out and install a 3x3x2 sanitary tee to pick up the shower and cap off the...
I was in the process of performing minor repairs on my tankless water heater when I realized that I was unable to fully stop the flow of water out of the hot side of my faucets. I then realized that it was cold water flowing from the hot side. The flow is steady and about 1/4 to 3/8 inch in...
View more questions Search
|
