Ask Experts Questions for FREE Help !
Ask
    cwash56's Avatar
    cwash56 Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 1, 2012, 11:22 AM
    Pictures of wiring outside condenser unit contactor to the thermostat?
    My dog pulle the wires from the house to the carrier condenser unit in the back yards.
    There are 4 wires coming from the house-blue ,red,green,white
    There are 2 wires(blue and brown)from the contactor,that were connected to these wires;with wire nuts
    The blue contactor wire still has the white wire attach,what else connect to the brown and/or blues contactor wire
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #2

    Feb 1, 2012, 04:40 PM
    Look inside your furnace at the control board. Where are the wires leading outside hooked on the board? Most likely, the red will go to the brown contactor wire, and the white will go to the blue, and the other to aren't used (unless you have a heat pump). Let me know about the wiring in the furnace, and we should be able to get you back in businness.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search


Check out some similar questions!

Condenser wiring to Thermostat [ 0 Answers ]

All the copper wires was stolen from my home. I just replaced the thermostat and air handler wiring, and re-installing an old AC condenser unit system to my home. Two low voltage wires (blue and yellow) are sticking out of the AC condenser. Does anyone have a wiring diagram on where the 2 wires...

Outdoor thermostat on compressor/condenser unit. [ 0 Answers ]

I have a Goodman MDL# GSH 130301AC condenser unit; with a (gas) Backup Heat Control. When I call for heat the Heat pump will not come on, however the back up heat fires off if the inside thermostat has a 5 degree diff or if I go to Emerg heat. A friend thinks it's the outside thermostat sensor; I...

Replacement Motor Wiring for condenser unit [ 4 Answers ]

I have a Lennox HS16-461V-4P. The motor bearings died and I ordered a replacement motor. The old motor (GE) had two purple wires that went to and from the capacitor mounting in the unit. It also had orange and black wires that went to line voltage. The new motor (Emerson) only has three wires...

AC condenser unit won't stop running - Even with the thermostat turned off! [ 1 Answers ]

I have a bryant furnace with AC system. I turned the system on for the first time this year & it didn't run. We didn't use it at all last year, but worked fine the year before. The 3 amp fuse on the furnace control panel was blown. I traced the problem to a short in the 2 wires between the...

Condenser Unit/Thermostat Wiring [ 4 Answers ]

Ok, so my dog chewed up my thermostat wiring to my condenser and I can't figure out how to wire it back up. I went to the local HD and bought more wire and came home thinking I would just splice it and be done. Well, it turned out not to be that straight forward. The thermostat wire is has two...


View more questions Search