 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
My furnace will not put out heat ,a number code came on 33 it has a new filter and a couple of the ducts had lose tape but as of yesterday the heat is not working I have 3 small kids and I keep my dad with me here and it is COLD, one time today as it was being reset it kicked on for a minute then...
My furnace has an electronic ignitor. When I first turn on the furnace, the electronic ignitor lights the pilot and I can see the flames. I have the furnace set on auto and once the heat reaches desired temperature the furnace shuts off. However, I can still hear the motor going but the furnace...
I have a Concord furnace model cg90cb. We are getting a code 3 fault. (pressure switch open with inducer on) It seems to be a condensation problem on the vent line. We do have two 90 degree elbows going around an offset (a short vertical run) can this cause condensation? And should the offst...
Brand new Goodman forced air furnace. When the thermostat drops below the temperature setting, the furnace tries to turn on... I hear a lot of clicking, for up to 5 minutes stratight sometimes, until finally I think I hear the flame come on and the unti starts up and heat follows shortly...
Where can I obtain a wiring schematic for a EPCO furnace model P-T-2-03-15-09
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
