Ask Experts Questions for FREE Help !
Ask
    lm0575's Avatar
    lm0575 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 20, 2012, 10:19 AM
    Fan stays on after heater shuts off Goodman gmp-050
    After the thermostat reaches the desired room temparature, in the heat mode, the fan keeps going just blowing cold air, sometimes it shuts off, but after a while it will kick on with the heat still being off, can you please help me to identify this problem?

    Thanks
    Luis M.
    SeattlePioneer's Avatar
    SeattlePioneer Posts: 97, Reputation: 9
    Junior Member
    		  
    #2

    Jan 20, 2012, 11:27 AM
    On the circuit board there is a relay that turns the power on and off to energize the fan motor. There is a reasonable probability that the relay isn't opening reliably and keeps the fan motor turned on for a while until the relay finally opens.

    You can test this by gently tapping on the circuit board relays with the handle of a table knife. Don't pound on it, just some gentle tapping that might cause the relay to open and shut off the motor.

    If the tapping causes the motor to shut off, you will need to replace the circuit board.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #3

    Jan 20, 2012, 04:36 PM
    I agree. Please let us know what you find.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman gmp 050-3: blower starts before draft fan [ 0 Answers ]

I have a Goodman GMP 050-3 gas furnace which worked fine last winter/spring. Nothing has changed and now the furnace fails to ignite. When I set the thermostat for heat, the blower motor immediately starts while the draft fan motor doesn't and of course the furnace doesn't ignite either. Blower...

Goodman GMP 050-3 furnace Blower Not Running [ 2 Answers ]

I have a Goodman gas furnace model #GMP050-3 Rev B that was put in service in 2002. The blower fan motor has stopped working and I need help troubleshooting it. It was working fine until a week ago when I noticed an electrical burning smell in the area it services. Now, when the thermostat calls...

Goodman gmp 050-3 1993 Model [ 1 Answers ]

Furnace was running fine the all the Sudden Stopped The Unit comes on the first stage vacume blower comes on then the Ingitor Comes on Heats up fine but gas is not opening and entering the tude to ingiagte and Start the Second Blower No Gas Enterneing pas the Gas Valuve . Check the...

Issue with GMP-050-3 IDB and PV [ 1 Answers ]

Indoor blower and positive ventilation fans cycle on and off without being called by thermostat. I have disconnected all wiring from thermostat with same results. Problem first started with the indoor fan, now the positive vent fan does the same thing. Please help.

Issue with Goodman GMP series gmp 050-3 [ 18 Answers ]

Hello everyone, I have an issue with my furnace. It just recently started happening, when running the ac the unit gets to the set temperature and then the unit clicks as if where going off and clicks again and keeps running. I looked inside and didn't see the status light blink.. Any help here?

View more questions Search