Ask Experts Questions for FREE Help !
Ask
    majorhayward's Avatar
    majorhayward Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 9, 2008, 09:50 AM
    Goodman gmp 050-3 1993 Model
    Furnace was running fine the all the Sudden Stopped The Unit comes on the first stage vacume blower comes on then the Ingitor Comes on Heats up fine but gas is not opening and entering the tude to ingiagte and Start the Second Blower No Gas Enterneing pas the Gas Valuve . Check the Service Light Code and it is a steady contunioy Blink Checked the Filter Ect The Service panel for the Trouble Codes states

    Raipid Contunious (incorrect Twining) Reverse Transformer secondary leads what the carp is that? Bad Transformer of could it be other problem?? Have Disable Kid and Wife and Money Is Tight
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 9, 2008, 06:42 PM
    Reverse Transformer secondary leads what the carp is that

    That is that the two leeds from the transformers secondary 24 volt side have been reversed changing the polarity. Usually that happens when a homeowner tries to do repairs on the unit. If you did not touch it then the neutral and hot leg to the furnace would have to be reversed and that usually caused other problems.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman Furnace Model GMPN100-4--No Heat [ 3 Answers ]

The inducer fan motor starts,the hot surface igniter heats up and the gas valve opens producing a nice blue flame for 3 or 4 seconds and the gas valve shuts off. There are no red flashing lights to indicate a problem with any components. This unit was built around 1993. Any ideas on what might be...

Goodman Model gmpn series heats then just stops [ 3 Answers ]

My unit will kick on and heat and then it will just stop working. Indicater light on board shows solid red as if everything is normal. Any Ideas?

Goodman model gmpn080-4 [ 4 Answers ]

Have a goodman model gmpn080-4 I lost blower limit pressure switch previously and seemed to be the same thing, ordered part and still does same thing. Thought it may have had a vacuum leak so I sealed the edges, as long as it is not connected (securely) to the exhaust pipe it runs fine. As soon as...

Looking for wiring schematic for goodman model clj48-1a it was missing on the unit [ 1 Answers ]

:confused: looking for wiring schematic for goodman model clj48-1a

Goodman Model A32-15 [ 1 Answers ]

I understand how ot wire abasic thermostat but on my Goodman I have OTC-OT1-OT2 & OT3. What are these for?

View more questions Search