 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a comfortermaker furnace with a problem
I have a comfortmaker furnace(n8mpn075b12b1).The furance is about 8 years old.The problem is,the furnace will run OK for 4 to 6 hours OK and then it will come on,combustion blower starts,igniter,then gas,burner comes on for about 5 seconds then shuts off.Will do this about three times,then shuts down.On the control board the led will blink 6 times then pause, then repeat.I can turn the power off and then back on and the furnace will work again for a while.Over night the furnace shut down,this time on the control board,the led blinked 6 times pause then 1 time pause and kept repeating.Again turned the power off and on.Waited about 10 seconds in between off and on.The furnace run OK heated up to 72 degrees.
|
||||
Check out some similar questions!
Furnace operates fine except during cycle it will shut down then come back on to complete cycle. Could this be the blower relay or something else?
I have a Goodman Gas Furnace and the light blinks 3 times and says the pressure switch stuck open. What do I need to do?
"We have a concord 80 plus gas furance, sometimes when the furance comes on ignites and within a few seconds it shuts off then it does this a couple more times until the blower shuts off."
Need help. Not sure if having problem with stat or furnace. Stat was programmed to 68, and on "Auto", but furnace kept running past 79 and non-stop. I turned off the stat but it still heated up till the circuit was shut off. I left it off for at least an hour then clicked it back on. This solved...
I have an Amada 90 gas furnace with a dual stage Aprilaire 6202/6203 control panel, and an Aprilaire thermostat. When I turn on the thermastat for heat, the furnace turns on, the fan starts, the thermocoupler glows, and the burners light. Within about 10 seconds, it all shuts down, and begins the...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
