Ask Experts Questions for FREE Help !
Ask
    Tadnjj's Avatar
    Tadnjj Posts: 4, Reputation: 3
    New Member
    		  
    #1

    Jan 13, 2012, 02:56 PM
    Poor performance
    Soot build-up, even after thorough cleaning of all exhaust. I have always used "Marth" brand premium pellets.
    Tadnjj's Avatar
    Tadnjj Posts: 4, Reputation: 3
    New Member
    		  
    #2

    Jan 13, 2012, 03:16 PM
    Poor performance
    Have a Farenheight 50 pellet furnace. Have replaced gasgets, cleaned all exhaust and tubes, fresh air intake is clear. I suddenly get a lot of soot in the burn chamber. I've put on a larger exhaust chamber and fan per mfgr. Suggestion. If I set the stove to burn pellets, the fire pot gets over filled with pellets, so I turned it down, telling the stove I'm burning corn, then it usually won't overfill the pot with pellets. Does anyone know if this furnace has an adjustment for the auger? The mfgr says with the stove set on pellets, the auger should run for about 6 seconds out of 10 second cycle and this is what it does, yet will overfill the fire pot after about one hour of running. So.. "
    1 what's causing all the soot?
    2 why does it overfill fire pot when it's set for pellets? Pellets is all I ever burn and have always used "Marth" brand premium pellets.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs and Stratton 14.5 HP mower engine poor performance [ 1 Answers ]

I am just getting my rider mower running after two years sitting. I put in new gas, flush gas line, new gas filter, new plug, new oil, new oil filter. Would only start with starter fluid. I cleaned out carburator, drained gas, spray with carb cleaner, re-assembled. It starts now but only runs...

Poor performance from pump [ 3 Answers ]

I am on a flow well and was having low water pressure and air spitting from pipes. The points were bad on pump motor. Replaced motor and primed tank and am still having low water pressure and spitting. Could I have a leak in a pipe and sucking in air? Or is gage set wrong? ( is set for 50 psi)

Poor Internet Performance! [ 3 Answers ]

Hi guys. Am expiriencing a problem with 3 of the machines in our office. We have almost 24 computers connected to the LAN and internet. 21 are accessing the internet perfectly well (through a 24 port switch connected directly to the gateway ) but the 3 machines which have been connected through...

Poor performance [ 4 Answers ]

Have a 95 escort 16v lx which is spluttering when warm, as though it`s not getting fuel, it only does this when driving not when you dip the clutch or out of gear. If you turn off the engine and turn back on problem goes for a short time then comes back, its been on diagnostic computer at ford,they...

View more questions Search