Ask Experts Questions for FREE Help !
Ask
    calljake's Avatar
    calljake Posts: 2, Reputation: 1
    New Member
     
    #1

    Jan 1, 2012, 10:14 AM
    Armstrong Ultra II 90 inducer fan stays on
    Inducer fan will not shut off when tstat calls for heat in occupied mode, but then setback temp/time for tstat says stop call for heat. So just as tstat says stop the call for heat, and it yet has fired up, the inducer motor will just keep running. What controls this functioin.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Jan 1, 2012, 01:22 PM
    Not very savy with Armstrong,but most I`ve ever worked on the inducer ,like most every other part of furnace is controlled by the circuit/control board
    ,can you trace the wires hooked to inducer and find where they are tied to?
    calljake's Avatar
    calljake Posts: 2, Reputation: 1
    New Member
     
    #3

    Jan 1, 2012, 02:12 PM
    That will be my next step, appears to come from control board. When inducer fan stays on, I actually have to remove black power wire that feeds this fan from a relay. So could it be this small relay? Control board feeeds 24 volts to this relay.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #4

    Jan 1, 2012, 02:22 PM
    Yep, probably the relay,, in most cases you can`t replace just the relay, its made in and part of the control board (means replacing the board

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Armstrong ultra sx-80 furnace [ 1 Answers ]

I have an ultra sx-80 furnace it seems to work fine until it reaches set temp finally it kicks off and acts like it wants to keep trying to come back on every few seconds it will keep doing this until temp falls under set level then kicks back on and works fine until hits set level again then it...

Armstrong sx 80 furnace just clicks never lighys and inducer blower won't start [ 0 Answers ]

My armstrong sx 80 furnace won't start just clicking noise by control board Inducer blower won't start and furnace won't light

Armstrong ultra SX 80 [ 8 Answers ]

http://i17.photobucket.com/albums/b64/nanayeki/DSCF0260.jpg Hi, I need to know the color code of a resister which is missing in the circuit board, I try to replace it because it was burned. The serial number of the furnace is :GUJ100D14-3 A. The circuit board number is: FCC-1A 40403001 ...

Armstrong Ultra V [ 1 Answers ]

Armstrong Air Ultra V, 4 yrs old: Problem: *Igniter comes on with bright red/blue flame *Burners then come on *Fan blower comes on *Shortly after blower comes on, burners go out, and blower continues to run *Igniter comes back on *Burners then come back on *Then Burners go out again...

Armstrong sx ultra 93 [ 1 Answers ]

I was wondering what the color code was for the r1 resistor... my was a little burnt and I can't tell what the proper color code is.


View more questions Search