Ask Experts Questions for FREE Help !
Ask
    jasonlecah's Avatar
    jasonlecah Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 14, 2009, 11:48 AM
    Armstrong sx ultra 93
    I was wondering what the color code was for the r1 resistor... my was a little burnt and I can't tell what the proper color code is.
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #2

    Nov 14, 2009, 01:40 PM
    This might be a tough one. In the field, circuit boards are replaced, not repaired. You may try to find a pic of the board online, but even that may be of little use. Different revisions of the same component may incorporate different resistors.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Armstrong Ultra SX 80 furnace won't stay on [ 16 Answers ]

We have a Armstrong Ultra Sx80 furnace, model GUJ050D10-3A, with a HeatCraft Control Board, cat number 70k98 (40403001). Everything fires up fine… thermostat, inducer motor/fan starts, then ignitor, gas, and the burners light, etc. After the burners are lit for 30 seconds, the blower starts to...

Armstrong ultra sx-80 furnace problems [ 4 Answers ]

I have an armstrong ultra sx-80 gas furnace my problem is when I turn the unit on it will start up fine when I set it to heat, run for a few minutes then the flame dies. The blower stay on and will not shut off until I unplug the unit. The heat never reaches it's set point. If I wait for about 30...

Armstrong Ultra V [ 1 Answers ]

Armstrong Air Ultra V, 4 yrs old: Problem: *Igniter comes on with bright red/blue flame *Burners then come on *Fan blower comes on *Shortly after blower comes on, burners go out, and blower continues to run *Igniter comes back on *Burners then come back on *Then Burners go out again...

Armstrong ultra 80sx shuts off [ 0 Answers ]

Hello my ultra sx 80 lights up has pilot and burners light up for 10 to 15 seconds then turn off, I replaced Igniter and flame sensor assemby. Still the same Thanks

Armstrong ultra sx 80 furnace no pilot light [ 3 Answers ]

We've had a problem the last 2 winters with our furnace, always fixed but last night the furnace stopped working. We checked and there was no pilot light. Actually in this model we don't even know where we would light it. Someone told me it might be the thermo couple but I am in need of another...

View more questions Search