Ask Experts Questions for FREE Help !
Ask
    nomadken's Avatar
    nomadken Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 21, 2011, 05:00 PM
    Furnace 383KAV error code 13?
    Must do a Power down, 1st thing in the morning, then it runs great all day (off at 9:00 am, on at 5:00 pm, off at 9:pm) BUT then it will NOT start up without a Power down then it will run again all day every day!
    This is a Day & Night unit from the 94 time frame.
    Model No. 383KAV048111
    Serial No. 4894A14571

    Ken
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Dec 21, 2011, 07:51 PM
    That's why they call it a Day and Night, it don`t know wheather to run during day or during the night, but can`t do both,
    Does it have a control/circuit board on it ? If so does it have a LED light that might be flashing a code
    And if so count the flashes
    Then look on the inside of door/cover and see if there anything to tell you what the code is telling you to look for

    I`m not a day/night tech so don`t know a lot about them
    ,, let us know what you find
    nomadken's Avatar
    nomadken Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Dec 21, 2011, 09:02 PM
    Not Funny!
    One can see the error code is 13!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant 383KAV Furnace - Code 14 - Not getting 120 volts to ignitor [ 4 Answers ]

Still scratching my head on this one. Everything appears to be working fine on my furnace, except that the ignitor is not getting juice to glow orange/white, hence the gas is not igniting? I disconnected the ignitor harness from the control board, ran the test sequence again, and determined that I...

383KAV Bryant Furnace - Code 14 Not getting 120 volts to ignitor [ 1 Answers ]

Still scratching my head on this one. Everything appears to be working fine on my furnace, except that the ignitor is not getting juice to glow orange/white, hence the gas is not igniting? I disconnected the ignitor harness from the control board, ran the test sequence again, and determined that I...

Bryant 383KAV error code 34 [ 1 Answers ]

After reading a couple of posts, I cleaned the flame sensor. When that didn't work, I bought a new one and installed it. I am still getting the same code. The burner lights for approximately 3-5 seconds, then cuts off. The thermostat is calling for heat. What am I missing?

Furnace error code? [ 1 Answers ]

I have a Bryant 376CAV furnace. The LED light is flashing "short - long - long." There is no sticker posted explaining what this sequence means. Help.:confused:

View more questions Search