Burners on ICECO 80PJ only stay lit for 2 minutes then shut off... help.

tshearin Posts: 1, Reputation: 1

New Member

Dec 20, 2011, 04:45 PM

Burners on ICECO 80PJ only stay lit for 2 minutes then shut off... help.

Burners on ICECO 80PJ only stay lit for 2 minutes then shut off... help.

wmproop Posts: 3,749, Reputation: 91

Ultra Member

Dec 20, 2011, 08:29 PM

Try cleaning the flame senser with fine steel wool or sandpaper
Tell us how it works out

Add your answer here.

Check out some similar questions!

Burners will not stay lit [ 1 Answers ]

Unit purges, ignitor lites, burners lite and fan kicks on but burners turn off shortly after. Unit tries to start again. It goes through this 3 times then turns off unit completely. When I take the panel off and turn unit off then turn it back on, sometimes it stays on and works perfect. But once...

Burners do not stay lit. [ 3 Answers ]

Burners do not stay lit. I have a brand new Goodman GPG13 package unit with a 138,000 BTU natural gas furnace. The furnace has six (6) burners and an electronic spark ignition. All burners light, then (after about one (1) minute) the bottom burner or bottom two burners sputter or just go out may...

Why will my burners not stay lit [ 1 Answers ]

My forced air furnace does not stay lit when the heat is turned on. I climbed into the attic where it is located and had my wife set the thermostat to heat. I observed the burners light and watched the Honeywell limit switch start to do it's thing but after about a minute the limit switch...

Burners won't stay lit [ 2 Answers ]

-- need more help in figuring out flame sensor or roll out switch - Weather King --- ICECO --- 80 PJ --- forced air --- Honeywell valve (on/off switch)---burners light for 1 or 2 seconds, then go out