Ask Experts Questions for FREE Help !
Ask
    nitroman311's Avatar
    nitroman311 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 16, 2011, 08:46 PM
    Furnace rollout switch reset?
    I have carrier as well and I have a problem with the limit switch my burner fires up but only stays lit for a few seconds I have 4 reset buttons when I reset them the blower come on for a little while and turns off thanks for the help
    gscott612's Avatar
    gscott612 Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Jan 4, 2012, 08:40 AM
    I have a gass furance the thernostat is set at 76 degrees the tempture is only 70 degrees in the house what's wrong with furance I have installed the house
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trouble with furnace ad rollout switch [ 1 Answers ]

The furnace comes on OK. But when the blower motor comes on the flame in the firsttube from the left looks like it is shooting back out torwards the front of the furnace. It makes a popping sound when it does this almost like a low backfire. It is a goodman.

Tempstar Furnace tripping rollout switch [ 3 Answers ]

Hi, This just started last night. Furnace would blow cold air and the only way to shut it off was to hit the main switch on the furnace. After some research I found that the rollout switch was tripped. I reset it and it worked for 1 cycle. Upon starting back up it tripped again. Just...

Limit or rollout switch open concord furnace [ 1 Answers ]

I have a Concord 80 plus furnace. The code I'm getting is Limit or rollout switch open. The burner goes out after a few minutes and the blower motor keeps running. If I wait it resets itself after 15 minutes it will do it 3 times then it won't reset for an hour. I found two limits on each side of...

Open rollout error code in 2 yr old Goodman furnace,but rollout tests good [ 5 Answers ]

Vgftft

Bryant furnace - must press manual rollout reset for burner to ignite [ 2 Answers ]

My Bryant 350MAV furnace is not working properly. While the blower is first running it flashes a code 12. Then the light goes on solid and the burner never ignites. If I hold the manual rollout reset button for 20 seconds the ignitor starts to glow and the burner ignites. What needs to be...

View more questions Search