Ask Experts Questions for FREE Help !
Ask
    ejanota's Avatar
    ejanota Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 8, 2011, 12:04 PM
    Sv9500 his terminal
    Can someone tell me how to locate the his terminal on a honeywell SV9500

Check out some similar questions!

Smart valve sv9500 no glow? [ 0 Answers ]

Smart valve sv9500 I have 29volts to the valve and 29v out to the ignite but no glow I have replaced the ignite and still no glow is it the valve. I have also changed the control board and still no glow I starting to think it's the valve can anybody help..

Do I connect both W1 and W2 to the W terminal [ 1 Answers ]

My old wires are labeled Y1 R G1 W1 and W2 . I am trying to install the RTH2300 Honeywell thermostat. Do both the W1 and the W2 wires get put on the W terminal together

Quatro Furnace model hw sv9500 heater not blowing [ 0 Answers ]

I just replace a dual blower this summer but not when I run my heater I can hear it running but its not blowing out any heat. I called the guy who replace the blower and he talked me through something's. I jump started it some how listening to his instructions but it only work for a minute or two....

Where is my filter? SV9500 [ 2 Answers ]

I have a Consolidated Industries Furnace model number HW SV9500. I cannot find the filter on the thing. I was talking to a friend and he says it may be aftermarket. I feel stupid for asking this but would feel more stupid for ignoring it.

Tempstar SP80 w/SV9500. No pilot. [ 7 Answers ]

Woke up a little frosty this morning. Furnace is blowing, but no heat. I pulled the top cover on the SP80 and witnessed the startup sequence. I see no glow from the smart valve ignoter/flame rod assembly (Q3400) and the pilot never lights. The small motor/fan that gets air flow going is running,...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.