Ask Experts Questions for FREE Help !
Ask
    joepride009's Avatar
    joepride009 Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 8, 2011, 09:10 AM
    Coleman model DGAT056BDD
    Replaced ignigter board and now thermostat and pilot not doing anything. 5 wires on right side of brd. Red and brown jumped together black coming off load line box and 2 dark blue wires need to know what order they go in.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #2

    Dec 8, 2011, 04:51 PM
    Going to need some pictures on this one. And need to know where the wires from the board go to. The more pics the better. One step at a time, and we should be able to get you back in heat.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Coleman model BRCQ0301BEG [ 1 Answers ]

Is this unit a heat pump, or is it electric furnace only with air conditioning?

Coleman model 7956-856? [ 0 Answers ]

Water is leaking a the bottom of our unit, near the center, by the seam, about a 1/4 from the floor, while the A/C is on... Can't find the drain pipe or the pan to check any water...

Coleman Evcon DGAT090BDD Model [ 0 Answers ]

I have a Blend Air II 7681-8171 Model... Once I turn on the on switch a red indicator light kicks on with a alarm ring as the light blinks on and off. What does this mean?

We have a coleman model brcq0301beg [ 0 Answers ]

As I was pulling high weeds from around unit a wire was accidentally pulled could not get power at all to unit then reattached wires (red and white) to two blue one nothing then went to unit inside then change burnt fuse unit comes on but not outside took panel off and can start manually but...

Coleman Evcon Furnace #DGAT056BDD [ 20 Answers ]

I have a coleman evcon furnace in my double wide. Yesterday it ran fine, today not so good. I can see the "glow plug" light up and then ignite the unit so there is flame and the blower motor turns on... but after a 2 minute run it shuts back down and the air is less then warm during that 2 minutes....


View more questions Search