 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
We have a coleman model brcq0301beg
As I was pulling high weeds from around unit a wire was accidentally pulled could not get power at all to unit then reattached wires (red and white) to two blue one nothing then went to unit inside then change burnt fuse unit comes on but not outside took panel off and can start manually but that's all what may be problem
|
||||
Check out some similar questions!
My husband just replaced our thermostat and he is unable to find the correct setting for the anticipator. Would you happen to know what this should be set on? Thanks!
Occasionally an alarm sounds on our eb17b funace. A label mentions something about an attic fan needing servicing. We don't have an attic. There is a hose above the funace that goes to the roof. Is there a sensor up there that needs servicing?
We have a coleman direct vent air furnace in a mobile home. Uses propane. Trying to find owners manuel or just figure out where the filters go. It seems to be all sealed tight. I know it has to have filters some where.
I am trying to help a friend with a heating problem. He has a Coleman Model 3500A816 electric furnace with a heat pump which are controlled by a Honeywell Chronotherm T8611G1103 thermostat. It appears that the heating elements are not being turned on because the air from the registers is not very...
I just bought a house that has one of these in the garage. I can get the pilot light to go== But as soon as I go to put it to on it goes out? It also has a little gas lever that I have fooled around with but it just doesn't want to go into a pilot light stay lit mode. HELP!!
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
